Schoobrary رجوع
العودة إلى البحث
رسائل ماجيستير الانجليزية 2011 e709c873-3f12-40e9-b2d3-8abe7e18d19f

High throughput method for the analysis of pharmaceutical active ingredients using tris (2,2 bipyridyl) ruthenium(II) - peroxydisulphate chemiluminescence systems in two-chip device

Eiman Nasser Humaid Al-Gharibi, Salma Mohammed Z. Al. Kindy, Fakhr Eldin O. Suliman, Haider A. J. Al. Lawati

كلية العلوم-جامعة السلطان قابوس · عمان

الموضوعات

علوم بحتة وطبيعية

الملخص

A novel, rapid, economic, sensitive and environmentally friendly chemilumine scence (CL) microfluidic system has been developed for the determination of cetrizine hydrochloride (CET) and levofloxacin (LEV) in pharmaceutical and biological samples. The CL method is based on the oxidation of tris (2, 2 bipyridyl)ruthenium(II) by peroxydisulphate in a two chip device. For CET, three instrumental setups were tested in order to find the most economical, sensitive and high throughput setup. In the first setup, a continuous flow of sample and CL reagents was used, whereas in the second setup, a fixed volume (2 uL) of (Ru(bipy)344) was introduced into a continuous infusion of peroxydisulphate and the sample. In the third design, a fixed volume of sample (2 uL) was injected while the CL reagents were continuously infused. The CL signal was enhanced 200 % when the third setup was used compared to the other two setups. Up to 180 samples of CET can be analyzed in an hour consuming minute quantities of reagents. In order to increase the sample throughput further, parallel analysis was carried out for the analysis of LEV. Up to 720 samples of LEV can be analyzed in an hour. Various parameters that influence the CL signal intensity were optimized. Under the optimum conditions, a linear response was obtained for the range of 50 ug L to 6400 ug L-1 and 100 ug Ľ" to 7000 ug L-' for CET and LEV respectively. The detection limit was found to be 15 ug L (S/N = 3) for CET and 44 ug - and 64 ug L-?for the two detectors of LEV respectively (S/N = 3). The amount of consumed sample was only 2 uL, from which the detected amount of CET was found to be 6.5 x 10-14 mol and 2.4 x 101 mol and 3.5x 10 mol respectively for the two detector of LEV. This procedure was successfully applied to the analysis of CET and LEV in pharmaceutical formulations and biological fluids.

التعريف والنوع

رقم الوثيقة
e709c873-3f12-40e9-b2d3-8abe7e18d19f
رقم العقد
0
نوع الوسائط
Crawler
نوع المحتوى
الرسائل العلمية
صيغة المصدر
رسائل ماجيستير
نوع الملف
pdf text
أسماء الملفات
1374647_1.pdf

بيانات النشر

ألقاب المؤلفين
[{"name_ar":" Eiman Nasser Humaid Al-Gharibi","title_ar":"اعداد","title_en":"Preparation"},{"name_ar":" Salma Mohammed Z. Al. Kindy","title_ar":"اشراف","title_en":"Supervision"},{"name_ar":"Fakhr Eldin O. Suliman","title_ar":"اشراف","title_en":"Supervision"},{"name_ar":"Haider A. J. Al. Lawati","title_ar":"اشراف","title_en":"Supervision"}]
اللغة
English

المصدر والدورية

اسم المصدر
High throughput method for the analysis of pharmaceutical active ingredients using tris (2,2 bipyridyl) ruthenium(II) - peroxydisulphate chemiluminescence systems in two-chip device

المحتوى والصفحات

عدد الصفحات
0
ترجمة الملخص
تم وضع طريقة جديدة وسريعة واقتصادية وحساسة وصديقة للبيئة وذلك لتحليل عقارين يحتويان مجموعة أمين ثلاثي وهما سیتریزین هیدروکلورايد وليفوفلوكساسين. تعتمد الطريقة على إستخدام تقنية المايكروفلويديك التفاعل هذين العقارين مع مركب الروتينيوم الثنائي ثلاثي البريديل -( tris ( 2 , 2 - bipyridyl ) (( ruthenium ( II الذي يؤكسد بالبروكسي دي سلفات (peroxydisulphate) بوجود الضوء كعامل مساعد الإنتاج وميض ضوئي. ثلاث طرق مختلفة اختبرت للوصول للطريقة المثلى للحصول على سرعة عالية في التحليل وأكثر دقة واقتصادية. في الطريقة الأولى أستخدم. تدفق مستمر لكل المواد بينما في الطريقة الثانية أستخدم تدفق مستمر للسيتريزين والبروكسي دي سلفات بينما يتم حقن كمية معينة من الروتينيوم الثنائي ثلاثي البريديل (2 میکرولیتر). في الطريقة الثالثة تم حقن كمية معينة من السيتريزين (2 میکرولیتر) وأستخدم تدفق مستمر للروتينيوم الثنائي ثلاثي البريديل والبروكسي دي سلفات. وجد أن الطريقة الثالثة التي يتم فيها حقن العينة لمدة 20 ثانية فقط تزيد من قوة الوميض الضوئي وذلك مقارنة بالطرق الأخرى بنسبة 200%. عدد عيتات سیتریزین هیدروکلورايد التي يمكن تحليلها باستخدام هذه الطريقة يصل إلى 180 عينة في الساعة وباستهلاك كميات قليلة جدا من المواد. كما تم إستخدام طريقة التحليل الموازي التحليل ليفوفلوكساسين. وصل عدد العينات التي يمكن تحليلها باستخدام هذه الطريقة إلى 720 عينة في الساعة كما تم تحديد الظروف المثالية لتفاعل إنتاج الوميض الضوئي. كانت المنحنيات المعيارية خطية ما بين 50 و 6400 مایکرو جرام في لتر للسيتريزين هیدروکلوراید, و 100- 7000 مايكرو جرام في لتر لليفوفلوكساسين. وقد كان الحد الأدنى للكشف عن السيتريزين هيدروكلوراید 15 مايكرو جرام في لتر وباستخدام التحليل المتوازي وجد الحد الأدنى للكشف عن الليفوفلوكساسين 44 و 64 مایکرو جرام في لتر.هذا وقد تم تطبيق هذه الطرق لتحليل هذه المواد في المستحضرات الطبية والسوائل الحيوية وكانت النتائج دقيقة ومتوافقة مع المقادير المسجلة لهذه الأدوية في مستحضراتها, ولم يكن هناك تداخل المواد الأخرى الموجودة في هذه المستحضرات وبين المركب المراد تحليله.
كلمات الباحثين
Chemistry

إشراف وإعداد

الإشراف
Salma Mohammed Z. Al. Kindy, Fakhr Eldin O. Suliman, Haider A. J. Al. Lawati
الإعداد
Eiman Nasser Humaid Al-Gharibi

الاقتباسات الببليوغرافية

APA

Eiman Nasser Humaid Al-Gharibi،وآخرون. (2011). High throughput method for the analysis of pharmaceutical active ingredients using tris (2,2 bipyridyl) ruthenium(II) - peroxydisulphate chemiluminescence systems in two-chip device. أطروحة(رسائل ماجيستير). كلية العلوم-جامعة السلطان قابوس. عمان.

MLA

Eiman Nasser Humaid Al-Gharibi،وآخرون. High throughput method for the analysis of pharmaceutical active ingredients using tris (2,2 bipyridyl) ruthenium(II) - peroxydisulphate chemiluminescence systems in two-chip device. 2011. كلية العلوم-جامعة السلطان قابوس، رسائل ماجيستير.